turbine cylinder

This paper describes the procedures and process of welding repair for turbine cylinder cracks in Nanhai A Power Plant.

介绍南海市发电A厂汽缸裂纹补焊的处理工艺和处理过程。

互联网摘选

Method and application of manufacturing hydroxyl acid from used oil for mold and core sand binder is introduced. These oil include motor oil, insulating oil, diesel oil, turbine oil, cylinder oil, etc.

介绍了一种用机械油、绝缘油、柴油机油、汽轮机油、汽缸油等各种废油制作羟基酸的方法及其作为型（芯）砂粘结剂的应用。

互联网摘选

This paper analyzes the loss in through-flow area which has an effect on steam cylinder efficiency, and also it discusses the fundamental principle and advanced technology of steam turbine through-flow area modification.

本文对影响汽轮机组缸效率的通流部分的损失进行了分析，论述了汽轮机通流改造的基本原理和先进技术。

互联网摘选

Repair of Crack on Slip Ring of Cylinder Diaphragm on Steam Turbine by Welding

汽轮机汽缸隔板滑环裂纹的焊接修复

互联网摘选

By analyzing the material and structure of the gas turbine combustion chamber with gas compressor cylinder proper, the key point of the assemble welding process has been worked out, and the special assembling tool set up has been designed as well.

通过对燃气轮机燃烧室兼压气机缸体的材料、结构进行分析研究，制订了装焊工艺要点，并设计了专用的装配工装。

互联网摘选

Repair welding for cracks on No.1 steam turbine cylinder in Nanhai A Power Plant

南海市发电A厂1号机汽缸裂纹的补焊处理

互联网摘选

For example, the steam cylinder bolt for ultra-supercritical turbine requires not only enhanced high temperature strength and ductility, but also good corrosive and wearing resistance.

例如：用于超超临界汽轮机组的汽缸螺栓，不但要求具有足够高的高温强度和韧性，而且要求良好的抗腐蚀和耐磨性能。

互联网摘选

Based on terminal conditions of numeric analysis, numeric analysis of the relative expanding difference of shaft and cylinder of steam turbine was made at the different temperatures in the no-load work condition by ANSYS.

利用数值分析的边界条件，运用ANSYS有限元分析软件，对汽轮机转子及汽缸空负荷工况下，不同排气温度时的相对胀差进行了数值模拟。

互联网摘选

This paper describes three cylinder tandem compound four exhaust air-condensing reheat turbine.

简要介绍了本公司新开发的三缸四排汽600MW空冷汽轮机。

互联网摘选

Cold Welding Method for Repair Welding Cracks in Cylinder of Steam Turbine

冷焊法焊补修复汽轮机汽缸裂纹

互联网摘选

The designed thinking of a complex CNC surface grinding machine for turbine cylinder is narrated briefly.

概述了数控汽轮机缸体表面打磨机的设计思想.

互联网摘选